16-10
DSP Functions
The DSP Functions
are high-amplitude partials, the signal may clip. The Pad parameter on the F1 FRQ page will
reduce the clipping, but there’s no harm in keeping it if you like the sound.
EditProg:F2|RES(2P|LOPASS)|<>Layer:1/1||
Adjust:0.0dB||||||||Src1||:OFF||||||||||
||||||||||||||||||||Depth|:|0.0dB|||||||
||||||||||||||||||||Src2||:OFF||||||||||
KeyTrk:|0.00dB/key||DptCtl:OFF||||||||||
VelTrk:|0.0dB|||||||MinDpt:|0.0dB|||||||
||||||||||||||||||||MaxDpt:|0.0dB|||||||
<more||F1|FRQ|F2|RES|F3|||||F4|AMP|more>
Two-pole Lowpass Filter, -6 dB Resonance (LOPAS2)
Using this filter is the same as using two one-pole lowpass filters in successive algorithm blocks.
Since its resonance is fixed at -6 dB, it’s also the same as using 2POLE LOWPASS with the
resonance set to -6 dB. You’d use this filter when you want a 12 dB per octave rolloff but don’t
need to set a resonance level. This would leave you free to use another DSP function in the
algorithm, since it’s a one-stage function.
Parameter Range of Values
Adjust -12 to +48 dB
Key Tracking ± 2.00 dB per key
Velocity Tracking -30 to +60 dB
Source 1 Control Source list
Source 1 Depth -30 to +60 dB
Source 2 Control Source list
Source 2 Depth Control Control Source list
Minimum Depth, Source 2 -30 to +60 dB
Maximum Depth, Source 2 -30 to +60 dB
-80
-70
-60
-50
-40
-30
-20
-10
0
10 100 1000 10000 100000
Frequency in Hertz
Resonance = 0 dB;
cutoff frequency
from C 4 to C 10
Amplitude in dB
C 4 C 10
To Next Page
Loading...
