Kyocera ECOSYS FS-1020MFP User Manual

2M4/2M5/2M6/2M7
2-4-16
3 in 1 20/21 ppm model
Procedure
1. Insert the power plug and turn the
power switch on.
2. Make sure the Processing indicator and
the Attention indicator are turned on,
press and hold both Stop/Reset and
Mode Select key for more than 5 sec-
onds.
* : Perform the above while the front cover
is opened.
3. When the Processing indicator has
turned on, turn power off by pressing
the power switch.
4. Close the front cover.
5. When power is turned on by pressing
the power key, settings are activated.
* : During activation, Processing and
Attention are lit up. It will take approxi-
mately ten minutes.
* : Do not turn power off during activation.
6. Activation is finished when Attention is
lit.
Figure 2-4-35

Kyocera ECOSYS FS-1020MFP Specifications

General

Print Technology	Laser
Print Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Paper Capacity	250 sheets
Connectivity	USB 2.0
Monthly Duty Cycle	20, 000 pages
Time to First Page	8.5 seconds
Duplex Print Mode	Manual
Scan Type	Flatbed
Output Capacity	100 sheets
Maximum Paper Size	A4
Functions	Print, Copy, Scan
Memory	32 MB
Print Speed	20 ppm
Copy Speed	20 pages per minute
Maximum Scan Area	8.5 x 14 inches
Fax Transmission Speed	Not supported