Kyocera ECOSYS FS-1020MFP User Manual

2M4/2M5/2M6/2M7-1
1-4-2
(2) Paper misfeed detection condition
Figure 1-4-2 Paper jam location
Code Contents Conditions
Jam
location*
0101 Waiting for process package
to become ready
The process package does not return Ready in
185 seconds after a print request has been
accepted.
-
0105 Prevention of the runaway
motor
The process and fuser packages do not return
Ready in 185 seconds after a print request has
been accepted.
The regist sensor won't be detected of its on and
off for 480 s during the main motor is driven.
-
0106 Waiting for duplex print
request
Paper feeding request for duplex printing given by
the controller is unreachable.
-
0107 Waiting for fuser package to
become ready
The fuser package does not return Ready in 185
seconds after a print request has been accepted.
-
0111 Rear cover open Cover is opened during printing. -
0120 Controller sequence error
(Duplex print is requested
when duplex pages are not
present)
Controller issued a request for duplex feeding
while the pages for duplex print is not present in
the duplex unit.
-
*: Refer to figure 1-4-1 for paper misfeed indication (see page 1-4-1).
RS
RS
DUS
20/21 ppm model 25/26 ppm model
DPOS
DPTS
DP

Kyocera ECOSYS FS-1020MFP Specifications

General

Print Technology	Laser
Print Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Paper Capacity	250 sheets
Connectivity	USB 2.0
Monthly Duty Cycle	20, 000 pages
Time to First Page	8.5 seconds
Duplex Print Mode	Manual
Scan Type	Flatbed
Output Capacity	100 sheets
Maximum Paper Size	A4
Functions	Print, Copy, Scan
Memory	32 MB
Print Speed	20 ppm
Copy Speed	20 pages per minute
Maximum Scan Area	8.5 x 14 inches
Fax Transmission Speed	Not supported