2M4/2M5/2M6/2M7
1-3-24
Printing the event log
Procedure
1. Click the Event Log.
2. Click the check box to acknowledge.
3. The event log will be printed.
Figure 1-3-13
Drum rank settings
Drums are ranked in three depending on the fluctuation in sensitivity.
Exercising the procedures that follow the replacement of maintenance kit or drum unit, the rank of drum is
automatically set to the default, 2.
If the rank differs, set the correct rank manually.
If the rank is not properly set with the drum unit, it is possible that gray background may occur or the produc-
tivity of fine lines may be deteriorated.
Procedure
1. Check the rank of the drum.
Where the rank is found: Barcode label
affixed on the drum unit
2. Enter the correct rank of the drum.
3. Press Apply to complete.
Figure 1-3-14
*SPL001Z00117* DK1110 RANK 1 2 3
Drum unit
To Next Page
Loading...
