Troubleshooting
7-6 BASIC OPERATION GUIDE
Paper jam at Cassette1.
Paper jam at Cassette2.
Paper jam at Mp Tray.
Paper jam at Document
Processor.
Paper jam in printer.
A paper jam has occurred. Press the left [Select] key to
cancel the copying procedure.
Refer to Paper Jams on page 7-8 and remove the
jammed paper.
Refer to page
7-8
Place original and press
[Start].
The machine will attempt to make copies from any
originals that remain uncopied.
Reset all of the originals on the original table and try to
copy again.
—
Print overrun
This page isn't complete.
A data overrun error has occurred due to insufficient
memory.
To continue printing, press the right [Select] key.
To cancel printing, press the left [Select] key.
—
Remove originals in
document processor.
This appears if there is a document in the document processor
when the power is turned on. It also appears when the paper
has jammed while being fed from the document processor
because of the way it was placed.
Remove all the document pages inside the document
processor, and position them again correctly.
Refer to page 7-
12
Replace Toner. Toner has run out so further copying or printing is
impossible.
Replace the Toner Container.
Refer to page
6-3
Scan memory overflow. Job
is ended.
Scan memory overflow. Job is ended. Press the left
[Select] key to cancel the copying procedure.
There is insufficient memory available. To verify the
current amount of memory, print out a Status Page. Add
memory if necessary.
To cancel printing, press the right [Select] key. If Auto
Error Clear is set to On, printing will be automatically
resumed after a preset period of time. Refer to the
Advanced Operation Guide.
Try adding more memory. Refer to Expansion
Memory on page 5-7
—
Message Procedure
Reference
Page
To Next Page
Loading...
