Kyocera FS-1018MFP

Troubleshooting
BASIC OPERATION GUIDE 7-7
Send error. An error has occurred during e-mail transmission. The
possible error codes and their descriptions are as
follows.
1101: The server name of the SMTP server is not set
correctly. Use COMMAND CENTER and register the
SMTP Server Name setting correctly. Refer to
Chapter 6,
Advanced Operation Guide.
1105: The SMTP protocol setting is turned off. Use
COMMAND CENTER and turn on the SMTP protocol
setting. Refer to
Chapter 6, Advanced Operation Guide.
1106: The Sender Address setting under E-mail:SMTP is
not registered. Use COMMAND CENTER and register
the Sender Address setting. Refer to
Chapter 6,
Advanced Operation Guide.
210#: The network cable is disconnected or the hub that
it is connected to is not operating properly. Check to see
whether the cable is not connected properly or the hub is
not working properly.
220#: The network cable has become disconnected
during transmission or the hub that it is connected to has
stopped operating. Check to see whether the cable is not
connected properly or the hub is not working properly.
—
—
—
Refer to page
3-11
Refer to page
3-8
Toner low. Toner is running low.
Replace the toner container using a new toner kit.
Refer to page
6-3
Message Procedure
Reference
Page