Preparation
BASIC OPERATION GUIDE 3-5
4
Press down on the Stopper
Extension Lock and slide the
Paper Stopper towards the rear of
the cassette, to lock into place.
The Paper Stopper is now in
position for Folio and Oficio II size
paper.
Loading Paper in the MP Tray
Standard paper (60 to 90 g/m²), thick paper (90 to 163 g/m²), color paper,
transparencies, and letterhead paper can be used in the MP Tray. Always
use the MP tray when copying and printing onto special paper.
The types of paper and the number of sheets that can be loaded are as
follows:
• Standard paper (80 g/m²): 50 sheets
• Thick paper (120 g/m²): 25 sheets
• Thick paper (160 g/m²): 10 sheets
• Transparencies: 1 sheet
IMPORTANT: After loading the MP tray, use the Operation Panel to select
the paper size. (For details, refer to Chapter 5, Advanced Operation
Guide.)
To use non-standard size paper, register the default paper size. (For
details, refer to Chapter 5, Advanced Operation Guide.)
When using transparencies, use a type of film that can withstand the heat
of the fixing process. The following products are recommended: Arkwright
(LTR) and 3M PP2500 (A4).
1
Open the MP Tray until you hear it
click into place.
To Next Page
Loading...
