2NC/2NF/2NG/2NN/3P7/3P8/3P9
1-5-9
4. Remove the retard holder and the
retard roller by bending to inside the ful-
crum part of the retard holder.
*: Be careful not to skip a spring.
5. Check or replace the retard roller and
refit all the removed parts.
6. When replacing the new unit,proceed
as follows:
1)Performs maintenance mode U901
(Clr Paper FD Cnt) (see page 1-3-111).
Figure 1-5-14
Fulcrum section
Spring
Projection portion
Retard holder
Fulcrum section
Lower feed assembly
Retard roller
To Next Page
Loading...
