78 CHAPTER 3
Maintenance
9. Remove the swivel-style panel.
Refer to “Swivel-style Panel
Removal and Wear Pad
Replacement” on page 71 for
details.
10. Open the access cover and
remove the pin from the cylinder
rods.
Note:The cylinder pins top plates
are provided with two (2)
threaded holes to use as a
puller by inserting two (2)
½-NC bolts.
11. Remove the roller assemblies on
the follower panels (refer to
“Packer Roller Replacement” on
page 70);
12. Fold the follower panels over the
packer(Figure 126. “Packer with
follower panels in folded
position”);
Figure 126. Packer with follower
panels in folded position
13. Start the engine and engage the
hydraulic system;
14. Retract the cylinders;
15. Disengage the pump;
16. Stop the engine;
17. Remove the hydraulic hoses
from the cylinders;
Note:Use absorbent material to
catch oil spills.
DANGER
NEVER CLIMB IN THE HOPPER WHILE
THE
ENGINE IS RUNNING.
DANGER
NEVER CLIMB IN THE HOPPER WHILE
THE
ENGINE IS RUNNING.