37
6 Commissioning
NOTICE
Press key 16 to read display values up to that moment, the fault occur.
All display values are frozen.
6.5.1.2 With User Interface
With customer interface, a scrolling text with fault code, firing rate value, plain text and oper-
ating hours.
6.5.1.3 Resetting Faults
By programming unit:
Via customer interface:
NOTICE
This may result in a RESET of the O
2
trim when a fault of O
2
trim is pending (see chapter 7.3
Resetting O
2
Errors).
Contact your service provider in an event of a fault.
Press key 17 until the display shows STATUS the display shows the error code
press ENTER the display shows the plain text message (incl. running time counter
reading)
press key
Press the RESET key to reset a fault of ETAMATIC OEM.
To Next Page
Loading...
