Lanier LD225 - Saving as files; To store the fax document on the Document Server

Reception Features
106
5
Where Incoming Documents Are
Delivered - Output Tray
Specifying Tray for Lines
The optional extra G3 interface unit is re-
quired.
You can specify the document feeding
tray for each port (telephone, Internet
Fax, IP-Fax). For example, you can
specify documents received through
the G3-1 port to be fed to the “Internal
Tray 1” and documents received
through the G3-2 port to be fed to the
“Internal Tray 2”, facilitating separa-
tion of files. You can also set the ma-
chine to output Internet Fax documents
and ordinary faxes onto different trays.
Note
❒ To use this function, specify the port
and destination using [Specify Tray
for Lines]. See p.147 “Reception Set-
tings”.
Tray Shift
The optional finisher or shift sort tray
unit is required.
When the optional finisher unit is se-
lected for fax output, you can use the
Tray Shift function whenever a fax or
report is printed.
This is useful for separating faxes
stacked in the finisher output tray.
For example, if the previous incoming
fax was output to the left, the next in-
coming fax will be output to the right
and vice-versa.
Note
❒ You can turn this function on or off
with the User Parameters. See p.167
“User Parameters” (switch 19, bit 0).
❒ When the optional 500-sheet finisher
is installed, B5L cannot be output.
RussianC4-EN_Combine-F_FM.book Page 106 Tuesday, April 5, 2005 8:22 PM