Need help?Do you have a question about the LaserMech FiberCUT 2D and is the answer not in the manual?
Instructions for connecting the fiber optic cable to the cutting head.
Steps for installing the FiberCUT Monitor software and driver.
Lists settings that must be specified before operating the FiberCUT 2D.
General| Type | Fiber Laser Cutter |
|---|---|
| Laser Type | Fiber Laser |
| Focus Adjustment | Automatic |
| Positioning Accuracy | ±0.03mm |
| Repeatability | ±0.02mm |
| Control System | CNC Control System |
| Cooling System | Water Cooling |
| Power Supply | 380V/50Hz |
| Laser Power | 1000W - 6000W |
| Sealing | Fully Sealed |
To Next Page