PQIII Debugger | 32
©
1989-2021 Lauterbach GmbH
SYStem.Mode Select operation mode
Select target reset mode.
Format: SYStem.Mode <mode>
SYStem.Attach (alias for SYStem.Mode Attach)
SYStem.Down (alias for SYStem.Mode Down)
SYStem.Up (alias for SYStem.Mode Up)
<mode>: Down | NoDebug | Go | Attach | StandBy | Up
Down Disables the debugger. The state of the CPU remains unchanged.
NoDebug Resets the target with debug mode disabled. In this mode no debugging
is possible. The CPU state keeps in the state of NoDebug.
Go Resets the target with debug mode enabled and prepares the CPU for
debug mode entry. Now, the processor can be stopped with the break
command or any break condition.
Attach Connect to the processor without resetting target/processor. Use this
command to connect to the processor without changing it’s current state.
StandBy Debugging/Tracing through power cycles.
The debugger will wait until power on is detected and then stop the CPU
at the first instruction at the reset address.
Up Resets the target/processor and sets the CPU to debug mode. After
execution of this command the CPU is stopped and prepared for
debugging.
To Next Page
Loading...
