PQIII Debugger | 51
©
1989-2021 Lauterbach GmbH
TrOnchip.ENable Enable NEXUS trace register control
Enables NEXUS register control by the debugger. By default, NEXUS register control is enabled. This
command is only needed after disabling NEXUS register control using TrOnchip.DISable.
TrOnchip.RESet Reset on-chip trigger settings
Resets the on-chip trigger system to the default state.
Format: TrOnchip.ENable
Format: TrOnchip.RESet
To Next Page
Loading...
