LCR Pro1 - Connecting to PC

6 User Manual - LCR Pro1/Pro1 Plus - ver 1.06
The units listed below are applicable to the primary display measurements of the meter.
Table 1-2 Display of Measurement Units
Legend
Description
M
mega 1E+06 (1000000)
K
kilo 1E+03 (1000)
m
milli 1E–03 (0.001)
u
micro 1E–06 (0.000001)
n
nano 1E–09 (0.000000001)
p
pico 1E–12 (0.000000000001)
°
Degree, unit for phase angle measurement
%
Percentage, unit for tolerance measurement
H
Henry, units for inductance measurement
F
Farad, units for capacitance measurement
Ω
Ohm, units for resistance and impedance measurement
Connecting to PC
When the meter is connected to a PC via LCR Link1, it can be controlled remotely by the LCR Data Logger
software.
The LCR Link1 is a dongle style communication module that links the meter to PC. It uses a fully integrated
isolation technology to transfer data and charge the meter. This technology prevents PC noise interference so
that the meter’s performance and accuracy do not degrade when it is connected to PC.
The LCR Data Logger software can be used not only to configure the meter settings and parameters but also to
log the data to an Excel spreadsheet. It also provides some unique functions, such as:
• Data Filter: Set a threshold to prevent undesired data from being logged due to bad contact, switching
components, etc.
• Multi-component identification: The device performs step by step measurement on several components.
User doesn't need to switch parameters manually when switching from one component to another. The
device automatically sets the parameters according to the programming. It records the results and
reports Pass or Fail.