21 User Manual - LCR Pro1/Pro1 Plus - ver 1.06
Sorting Tolerance Menu
Sorting Tolerance menu is used to set the sorting tolerance ranges. When the meter works in sorting mode, it
beeps once if the component under test is within the tolerance range. If the component under test is out of the
tolerance range, the meter beeps three times. The default setting is 10% and the following settings can be
selected:
• 0.5%
• 1.0%
• 5.0%
• 10.0%
• 20.0%
• 30.0%
• Exit: Return to the measurement display.
Figure 2-28: Sorting Tolerance Menu
Sorting Reference Menu
Sorting Reference menu is used to view or set the reference values used in sorting mode. The following settings
can be selected:
• View REF. VA: view the existing reference values.
• Input REF. R: type in the new reference value for resistance.
• Input REF. L: type in the new reference value for inductance.
• Input REF. C: type in the new reference value for capacitance.
• Exit: Return to the measurement display.
Figure 2-29: Sorting Reference Menu
To Next Page
Loading...
