LCR Pro1 User Manual

23 User Manual - LCR Pro1/Pro1 Plus - ver 1.06
After 5 digits are typed in, the meter asks user to select unit. Press the "Up" or "Down" button to switch 4
options including mΩ, Ω, kΩ, MΩ. Then press the "Select" button to select the desired unit. Figure 2-32 shows a
display that the unit (kΩ ) has been selected.
Figure 2-32: Input Unit for Reference Resistance Value
Once the unit is selected, the meter asks user whether to save the value as the reference value or not. As Figure
2-33 shows, user can discard the value by pressing the "Up" or "Down" button or save the value by pressing the
"Select" button.
Figure 2-33: Save Reference Resistance Value from Inputting
If "Select" button is pressed, such value (80.860 kΩ) is saved as the new reference value for resistance sorting as
Figure 2-34 shows.
Figure 2-34: View Reference Values
NOTE
(1) The sorting reference value can be set up by either inputting a value or measuring a component and saving
the actual result as the reference value. To get detailed instruction on how to set up the reference value by
measuring, please refer to page 34: Holding the Display.
(2) After the battery is completely dead or hardware reset is performed, all the sorting reference values will be
reset to default. Please set these values again if necessary.

LCR Pro1 Specifications

General

Brand	LCR
Model	Pro1
Category	Measuring Instruments
Language	English