User Manual - LCR Pro1/Pro1 Plus - ver 1.06
Safety Notices
CAUTION
Cautions must be observed to avoid minor injury to yourself or damage to the product or other property.
WARNING
Warnings must be followed carefully to avoid personal injury or death or damage to the product
or other property.
Safety Considerations
Read the information below before using this meter. This meter is intended for use by qualified personnel
who recognize shock hazards and are familiar with the safety precautions required to avoid possible
injury. The following general safety precautions must be observed during all phases of operation, service,
and repair of this meter. Failure to comply with these precautions or with specific warnings elsewhere in
this manual violates safety standards for design, manufacture, and intended use of the meter. LCR
Research assumes no liability for the customer’s failure to comply with these requirements.
CAUTION
• Disconnect circuit power and discharge all high-voltage capacitors before testing.
• When measuring in-circuit components, first de-energize the circuits before connecting them to the
test tips.
• The battery must be charged by a computer USB port or a USB power adapter that provides output
voltage DC 5V ± 5%.
• This meter is for indoor use.
WARNING
• Use this meter only as specified in this manual, otherwise, the protection provided by the
meter may be impaired.
• Do not use the meter if it is damaged. Before you use the meter, inspect the case. Look for
cracks or missing plastic.
• Inspect the test tip sleeves for damaged insulation or exposed metal. Check the test tips for
continuity. Replace damaged test tip sleeves before you use the meter.
• Do not touch exposed metal in measurement. Keep your fingers on insulated test tip sleeves.
• Do not use the meter if it operates abnormally.
• Do not operate the meter around explosive gas, vapor, or in wet environments.
• Never use the meter in wet conditions or when there is water on the surface. If the meter is
wet, ensure that the meter is dried only by trained personnel.
• When servicing the meter, use only the specified replacement parts.
• Do not attempt to replace the internal lithium-ion polymer battery yourself. You may damage
the battery, which could cause overheating and injury. The battery should be replaced only by
an LCR Research Authorized Service Provider, and must be recycled or disposed of separately
from household waste. Don’t incinerate the battery.
• Do not use damaged cables or chargers, or charge when moisture is present. It can cause fire,
electric shock, injury, or damage to the product or other property.
To Next Page
Loading...
Need help?
General
