Flying Object Hazard
Always wear eye protection when cleaning
the LeeBoy Model 400 or 400T Roller
with compressed air or high-pressure
water. Dust, ying debris, compressed air,
pressurized water or steam may cause eye
injury.
Coolant Hazard
Wear eye protection and rubber gloves
when handling engine coolant.
• If contact with the eyes occurs, ush eyes with clean
water for 15 minutes.
• If contact with skin occurs, wash immediately with
soap and clean water.
Burn Hazard
Some of the machine’s surfaces become
very hot during operation and shortly after
shutdown.
• Keep hands and other body parts away from hot
machine surfaces.
• Handle hot components with heat-resistant gloves.
The safety messages that follow have CAUTION level
hazards.
Poor Lighting Hazard
• Ensure that the work area is adequately illuminated.
• Always install wire cages on portable safety lights.
Tool Hazard
Always use tools appropriate for the task at hand and
use the correct size tool for loosening or tightening
LeeBoy machine parts.
The safety messages that follow have NOTICE level
hazards.
• Any part found defective during inspection or does not
satisfy the proper standard or limit must be replaced.
• Always tighten components to the specied torque.
Loose parts can cause damage to the LeeBoy
machine or cause it to operate improperly.
• Only use replacement parts approved by LeeBoy.
Other replacement parts may affect warranty
coverage.
Follow the guidelines of the EPA or
other governmental agencies for the
proper disposal of hazardous materials
such as engine oil, diesel fuel, and
engine coolant. Consult the local
authorities or reclamation facility.
• Dispose of hazardous materials in accordance with
all applicable laws and regulations. Never dispose of
hazardous materials by dumping them into a sewer, on
the ground, or into groundwater or waterways.
• Clean all accumulated dirt and debris away from the
body of the roller and its components before you
inspect the roller or perform preventive maintenance
procedures or repairs. Operating a roller with
accumulated dirt and debris will cause premature
wear of roller components. Accumulated dirt and
debris also hinders effective roller inspection.
• Retrieve any tools or parts that may have dropped
inside of the roller to avoid improper roller operation.
• If any alert indicator illuminates during roller operation,
stop the engine immediately. Determine the cause
and repair the problem before continuing to operate
the roller.
Safety
LeeBoy Model 400 & 400T Rollers1-6
To Next Page
Loading...
