LeeBoy 400T - Parking Safety; Maintenance Safety; Receiving the Roller

Parking Safety
• ALWAYS park the roller on solid, level ground. If this
is not possible, park the roller at a right angle to the
slope.
• ALWAYS engage emergency brake when parking or
leaving the machine unattended.
• USE proper ags, barriers and warning devices,
especially when parking in areas of trafc.
Maintenance Safety
• NEVER work on the roller while the engine is running.
• NEVER ll the fuel tank while the engine is running.
• DO NOT change the engine governor settings.
• ALWAYS replace damaged or lost decals.
• DISCONNECT battery cables when working on the
electrical system or welding.
• If the battery needs a charge, be sure the battery
charger is OFF when making connections.
• BE SURE the correct battery polarity is observed
[negative (-) to negative (-) and positive (+) to positive
(+)], when connecting a battery charger or jumper
cable.
• DO NOT use hands to nd hydraulic leaks. High
pressure uid can penetrate the skin, causing severe
injury.
• DO NOT service or repair the machine in a raised
position unless supported by approved jacks and jack
stands.
RECEIVING THE ROLLER
The LeeBoy Model 400 and 400T rollers are thoroughly
inspected at the factory before shipping. However, road
hazards or other incidents may occur during transport
that result in damage. Inspect the machine as outlined
below and perform necessary repairs before placing the
machine in service:
1. Check the engine oil level as shown in the Engine
Operator’s Manual.
2. Check the fuel tank, cooling system, engine oil,
and hydraulic reservoir for proper levels and
contaminants. If contaminants are suspected, ush
and ll the system.
3. On the Roller, check all chains.
4. Check inside of the water tank for contaminants or
objects that could be harmful to the water system.
Ensure water ows freely from sprayer.
5. Check for fuel, oil, water and hydraulic leaks.
6. Check all hydraulic functions. Any repairs and
adjustments should be performed by a qualied
mechanic or consult your authorized LeeBoy dealer.
7. Check the vibrator to ensure it stops while the
machine is in neutral.
8. Check for missing parts. If parts are missing or
motor roller is damaged, consult your authorized
LeeBoy dealer.
9. Check the Emergency Brake to ensure it is
operating properly.
10. Check the seat belt.
Operation
LeeBoy Model 400 & 400T Rollers4-4