LeeBoy 400T - General Maintenance Information

worn or damaged parts--replace or repair promptly to
prevent damage to other areas of the machine. Daily
inspections should include checking for loose bolts,
uid leaks, worn or damaged hoses, and debris or dirt
accumulations to prevent potential service or safety
problems.
The maintenance program must be done based on the
machine “Operating Hours” recorded on the hour meter
or based on the “Periodic Schedule,’’ which is typically
done at the following time intervals:
Daily, Weekly, Monthly, Quarterly, Semi-Annually and
Yearly
GENERAL INFORMATION
This section gives the necessary procedures for
routine and general maintenance on the Model 400 and
400T Rollers. Follow all Maintenance Schedules and
Maintenance Procedures to maintain the machine in top
operating condition.
Maintenance must be a planned program that
includes periodic machine inspection and lubrication
procedures. The rst and most important requirement
for satisfactory paver performance is a clean machine.
The operator should inspect the machine daily for
Table 5-1. Periodic Maintenance Schedule
SYSTEM ITEM
Every 10 Hours
Daily
Every 50 Hours
Weekly
Every 100 Hours
Monthly
Every 250 Hours
Quarterly
Every 500 Hours
Semi-Annually
Every 1000 Hours
Annually
Roller Lubricate drum bearings. X
Hydraulic
Check oil level. X
Replace oil lter. X
Replace oil. X
Check/replace oil suction lter. X
Replace strainer ll cap. X
Engine
Inspect belts, replace if needed. X
Inspect air intake hoses and clamps. X
Inspect alternator and connections. X
Replace engine oil and oil lter cartridge. X
Check oil level - change at initial 50 hours. X
Electrical
Check all wiring connections. X
Service battery. X
Engine Air
Cleaner
Check/clean air cleaner element. X
Replace air cleaner element. X
Fuel
Replace fuel lter. X
Inspect fuel system hoses and clamps. X
Cooling
Check coolant level, rell if needed. X
Inspect coolant hoses and clamps. X
5
Maintenance
LeeBoy Model 400 & 400T Rollers 5-3