LeeBoy 400T - Starting and Stopping Precautions; Parking Precautions; Operating Precautions

Mounting and Inflation
• DO NOT inate a tire before all components are in
the proper position. Place tire in a safety cage and
inate to approximately 10 psi. Recheck components
for proper assembly. If improperly assembled, deate
and correct.
• Never hammer on a tire/rim assembly that is not fully
deated. If assembly is proper at 10 psi, continue to
inate to fully seat the tire beads, then completely
deate the tire to prevent localized overstretching
of the tube. Reinate to recommended operating
pressure.
• NEVER sit on or stand in front of a tire/rim assembly
during ination. Use a clip-on chuck and make sure
ination hose is long enough to stand to the side of the
tire while inating.
• DO NOT hammer components with steel hammers.
Use rubber, lead, plastic or brass-faced mallets to tap
components together.
Operation
DO NOT inate tires beyond the maximum
recommended ination pressure.
NEVER run a vehicle one single tire of a dual assembly
as the carrying capacity is dangerously exceeded and
can result in damage to the rim and tire
Mismatched rim parts are dangerous
and can cause severe injury.
Starting and Stopping
Precautions
• Check all around the roller to make sure there are no
people working on the machine or in the path of the
machine before starting. DO NOT start until area is
clear. Death or serious injury can occur to bystanders
from being crushed under a moving machine.
Check brakes, steering and other
control devices in accordance with instructions
before starting. Be sure emergency brake is applied
and the left Drive Throttle is in neutral.
• Latch seat belt (if equipped) and adjust to t snugly.
• Only start and operate the machine from the
operator’s seat. DO NOT bypass paver/nisher‘s
neutral-start system. If the system malfunctions, it
must be repaired.
DO NOT operate the engine in an
enclosed area without proper ventillation. Exhaust
gasses are odorless and deadly.
Parking Precautions
• Park roller on level ground whenever possible. On
grades, park machine with wheels securely blocked.
Always apply parking brake.
• Before leaving operator’s station:
1. Place left drive handle in neutral.
2. Turn off all accessories.
3. Set emergency brake.
4. Shut off engine.
• Always remove ignition key when leaving roller parked
or unattended.
Operating Precautions
• Always comply with local regulations regarding
moving equipment on public roads and highways.
• Know and use the hand signals required for a
particular job. Know who has the responsibility for
signaling.
• Make sure all lights and reectors comply with state
and local regulations. Keep them clean and in good
working order so they can be seen clearly by all trafc.
DO NOT stand between the equipment
and the truck while the truck is being coupled with
the paver/nisher. Death or serious injury can result
from being crushed between the two machines. DO
NOT ride on attachments.
Safety
LeeBoy Model 400 & 400T Rollers1-10