LeeBoy 400T - Fuel System Maintenance

3. Remove the air lter inner element.
4. Clean the inside of the air cleaner housing with a
clean, lint-free cloth.
5. Discard lters properly.
Severe engine damage can occur
if engine is operated without air lter properly
installed.
6. Carefully install the new air lter elements into the
housing.
7. Install the rear covers.
8. Start the engine, checking that it runs smoothly.
FUEL SYSTEM
Fuel Tank
The fuel level is indicated on the fuel gauge located
on the dashboard, and indicates the amount of fuel in
the tank. The green fuel cap for lling the machine with
diesel fuel is located on the front part of the machine.
(Figure 5-11)
Fuel Cap
Figure 5-11. Fuel Cap Location
NOTE: Fill the tank to FULL before the roller is
stored overnight to reduce moisture accumu-
lation in the tank from condensation.
The operator should NEVER be on the
roller while fuel is being added. NO SMOKING while
lling the fuel tank as all fuels for internal combustion
engines are ammable. Fill the fuel tank only in a
designated area where there is good ventilation and
a re extinguisher available.
NEVER ll the tank, check fuel level
or check for fuel leaks near an open ame or near
equipment that can create sparks.
Engine Fuel Filters
The fuel lter elements must be replaced as directed in
the Engine Operator’s Manual. (Figure 5-12) Replace
the fuel lters using the following general procedure:
Diesel fuel is very ammable. Use
extra caution and DO NOT spill fuel. DO NOT change
the fuel lter while the roller is running. DO NOT
change the fuel lter in an area near an open ame.
DO NOT smoke while changing the fuel lter.
Fuel Filter
Figure 5-12. Engine Fuel Filter Location
Maintenance
LeeBoy Model 400 & 400T Rollers5-14