Safety Decals Care
• Keep safety decals and signs clean and legible at all
times.
• Become familiar with the content and position of each
safety decal. Decals include important information.
• Replace decals and signs that are missing or become
illegible.
• When replacing parts that display a safety decal,
ensure the new part is also tted with the correct
safety decal.
• Obtain safety decals or signs from your authorized
LeeBoy dealer when needed.
Decal Installation (Sticker Type)
1. Be sure the installation area is clean and dry. Use
hot, soapy water to clean the surface where decal
will be applied. Thoroughly dry.
2. Measure and determine decal positioning before
removing the decal paper backing.
3. Remove the smallest adhesive backing of the split-
backing paper.
4. Align decal over the specied area and carefully
press exposed portion into place.
5. Slowly remove the remaining backing and carefully
smooth the remaining portion of the decal into place.
6. Small air pockets can be pierced with a pin and
smoothed using a piece of the decal backing.
Decal Installation (Top Protected)
1. Be sure the installation area is clean and dry. Use
hot, soapy water to clean the surface where decal
will be applied. Leave wet.
2. Measure and determine decal positioning. Remove
protective backing and soak the decal in clean,
soapy water before application. (This will help to
alleviate air bubbles when applying the decal.)
3. Smooth the decal into place with a squeegee and
check for air bubbles.
4. Small air pockets can be pierced with a pin and
smoothed using a piece of the decal backing.
5. When the decal is completely smooth, carefully
remove the top paper.
MACHINE SPECIFIC
PRECAUTIONS
Hot Material Precautions
• Wear protective gear for face, hands and feet when
operating the roller.
• Allow machine to cool before repairing or performing
maintenance on working components.
If hot asphalt touches skin, ush area
immediately with cold water. DO NOT apply ice
to the affected area. DO NOT attempt to remove
asphalt cement with products containing solvents or
ammonia. Get medical attention as soon as possible.
DO NOT remove radiator cap, drain
plugs, and service grease ttings or pressure taps
when engine is hot. Add coolant to the radiator and
perform other services only when the engine is
stopped and fully cooled.
Hydraulic Systems Precautions
• Make sure all components are in good working
condition. Replace any worn, cut, abraded, attened
or crimped hoses and metal lines.
DO NOT attempt makeshift repairs
using tape, clamps or cements. The hydraulic
system operates under extremely high pressure and
such repairs could cause serious injury.
Wear proper hand and eye protection
when searching for a high pressure leak. Use a
piece of wood or cardboard as a back stop (instead
of hands) to isolate and identify leaks. Pressurized
hydraulic uid or oil has sufcient force when it
escapes to penetrate the skin, which could cause
serious personal injury. Ensure pressure is relieved
before disconnecting line, hoses and valves.
If injured by concentrated high
pressure steam or hydraulic uid, seek medical
attention immediately. Serious infections or
toxic reactions can develop from hydraulic uid
penetrating the skin’s surface.
Safety
LeeBoy Model 400 & 400T Rollers1-8
To Next Page
Loading...
