OPERATING SAFETY
• ALWAYS wear OSHA-required safety equipment
when operating the roller.
• ALWAYS fasten your seatbelt when in the operator’s
seat while operating the equipment.
• ALWAYS make sure no person or object is in your line
of travel BEFORE starting.
• Work SLOWLY in tight areas.
• DO NOT run engine in a closed building for long
periods of time.
• AVOID steep hills and sharp turns if possible.
• REDUCE speed before turning.
• ALWAYS look BEFORE changing your direction of
travel.
• DO NOT leave the engine running without the operator
present.
• DO NOT start engine by “shorting” across starter
terminals. Machine will start in gear if normal circuitry
is bypassed.
• NEVER start engine while standing on the ground.
Start engine only from operator’s seat, with forward/
neutral/reverse (FNR) lever in NEUTRAL.
• Ensure water tank support is bolted down during
operation.
• Check the parking brake button to make sure it is
operating properly.
GENERAL INFORMATION
This section provides the Operating instructions for the
LeeBoy Model 400 and 400T Rollers. It is important to
read, understand and follow all precautions, operating
instructions, and warnings in this manual before starting
and operating the machine.
Failure to observe the operating
precautions and warning instructions provided in
this manual can cause serious injury or death. Only
authorized personnel who are trained in machine
operation, mechanical characteristics and safe
operation in varying terrain should operate the Model
400 and 400T Rollers.
The machine should be kept in good
mechanical condition at all times.
DO NOT operate a machine needing
repair. Be sure to place an information tag on the
instrument panel clearly stating “DO NOT OPERATE”
and remove key on a machine needing repair. Repair
all damage promptly as even minor damage can
result in major system failures.
DO NOT start or operate the Model
400 or 400T Roller before reading, understanding,
and following all information given in this section and
shown on the machine. The operator must read and
understand the function of all controls, indicators
and gauges before starting the engine. Serious
injury or death can result if these procedures are not
followed.
4
Operation
LeeBoy Model 400 & 400T Rollers 4-3
To Next Page
Loading...
