LeeBoy 400T - Change Engine Oil Filter; Change Engine Air Filter

DO NOT overtighten the drain plug.
5. Fill the engine at the oil ll cap with 15 quarts (14.2
liters) of oil. (Figure 5-8)
6. Reinsert the engine lubrication oil dipstick.
DO NOT start the engine before
changing the engine lubrication oil lter. Follow the
procedures listed here and in the Engine Operator’s
Manual.
Change Engine Oil Filter
The engine lubrication oil lter must be changed when
the engine lubrication oil is changed. (Figure 5-9)
DO NOT change the engine lubrication
oil when the engine and lubrication oil are hot.
Change when warm only. Hot oil can cause serious
injury.
DO NOT change the engine lubrication
oil lter with the engine running. Serious engine
damage or failure can occur.
Oil
Filter
Figure 5-9. Engine Oil Filter Location
After the engine lubrication oil has been changed,
proceed as follows:
1. Wipe the area around the engine lubrication oil lter
element and its mounting base with a clean cloth.
2. Place a container under the lter element.
3. Use a lter removal wrench to loosen and remove
the lter element by turning it in a counterclockwise
direction. Drain and discard the removed lter
element.
NOTE: Be sure the used rubber gasket is removed
and discarded with the lter element.
NOTE: Comply with environmental laws by properly
discarding used oil.
4. Wipe the inside area of the lubrication oil lter head
using a clean, lint-free cloth.
5. Put clean engine lubrication oil on the rubber gasket
area of the new lter element. Fill the new lter
element with the new oil.
6. Install the new lter element onto the lter head.
Carefully tighten the lter element (by hand only).
NOTE: Tighten the lter element as directed by the
lter manufacturer.
Change Engine Air Filter
The engine inlet air lter assembly uses a replaceable
lter element. (Figure 5-10)
Air
Cleaner
Cover
Air Filter
Access
Figure 5-10. Engine Air Filter Location
The air lter element should be
replaced every 100 hours of normal paver operation
or monthly. Replace the air lter element more
often for a paver that is operated under more severe
conditions. NEVER operate the engine without an air
cleaner element installed.
DO NOT service the air cleaner
element while the engine is running.
Use the following procedures to service the air cleaner
element:
1. Remove the back cover on air breather housing.
2. Remove the air lter outer element.
5
Maintenance
LeeBoy Model 400 & 400T Rollers 5-13