5.4008.8573.0 B
8-2 Troubleshooting
Table 8 Troubleshooting table machine (cont'd.)
Symptom
Possible cause Action
The water hoses leak. Turn off the machine and
contact your local Lely service
provider.
The water pump does not work. Contact your local Lely service
provider.
The wheels of the machine are
slipping.
The tires are worn out. Contact your local Lely service
provider.
There is too much friction in
front of the machine.
Contact your local Lely service
provider.
The alley is too slippery. Spray (more) water, the alley will
become less slippery.
The machine is not starting a
route.
The internal clock of the
machine is not set to the right
time.
Connect a smartphone that is set
to the right time to the machine.
The battery energy level is too
low. It needs to have at least
60% of its battery capacity plus
the energy needed for one
route.
Wait until the battery is charged
sufficiently. The machine will
skip the current route and start
at the point of time that both
the battery level is sufficient and
a route is scheduled on the
programmed day planning.
No route is programmed in the
day planning.
Make sure the day planning is
programmed correctly.
The machine gets lost or gets
stuck and can not finish its route
repeatedly.
The walls / borders are too dirty.
• Clean the walls and borders
of the cubicles.
• Manually navigate the
machine along the walls using
the command Wall follow.
When the machine touches
the walls it scrapes off the
dirt.
The routes need to be
reprogrammed to improve the
navigation.
Contact your local Lely service
provider to reprogram the
routes.
The floor is too dry.
• Use the water sprinkle system
of the machine more often.
Eventually have the routes
reprogrammed for this by
your local Lely service
provider.
• If the sprinkle water system is
not working see symptom
in novators in agriculture
To Next Page
Loading...
Need help?
General
