5.4008.8573.0 B
Troubleshooting 8-3
Table 8 Troubleshooting table machine (cont'd.)
Symptom
Possible cause Action
'The machine does not
sprinkle water'.
The wheel diameter is not
correct anymore.
Calibrate the wheels.
The tires are worn out. Contact your local Lely service
provider.
Ultrasonic sensor(s) do not
function properly.
Clean the ultrasonic sensors.
Ultrasonic sensors, gyroscope or
other components of the
navigation system are defect.
If sensors are not working
properly, contact your local Lely
service provider.
The machine can not find the
dump pit.
The dump pit is that dirty that it
blocks the machine.
Clean the dump pit.
The dump pit is frozen and it
blocks the machine.
Contact your local Lely service
provider for solutions to keep
the dump pit free of frost.
The machine got lost or stuck in
the barn and can not finish its
route.
Bring the machine back to the
charging station.
If this problem persists, see
symptom 'The machine is lost
and cannot finish the route'.
The programming of the route
needs to be improved.
Contact your local Lely service
provider.
The machine does not release
(all) the manure in the dump pit.
The dump pit is dirty. Clean the dump pit.
The dump pit is frozen. Contact your local Lely service
provider for solutions to keep
the dump pit free of frost.
The air valve is defect. Contact your local Lely service
provider.
There is a blockage due to dried
material in the manure tank.
Clean the manure tank (see
Clean the Manure Tank on page
6-10).
The manure is too thick or too
dry.
Spray (more) water.
The machine is not taking in
enough manure / the barn is not
cleaned well.
The floor guides are worn out. Contact your local Lely service
provider.
The manure scraper is worn out. Contact your local Lely service
provider.
The manure inlet suction strips
are worn out or teared.
Contact your local Lely service
provider.
in novators in agriculture
To Next Page
Loading...
Need help?
General
