1. Install the PCIe riser assembly. See “Install the PCIe riser assembly” on page 101.
2. Install the top cover. See
“Install the top cover” on page 134.
3. If necessary, configure the RAID array using the Setup utility configuration.
4. Complete the parts replacement. See
“Complete the parts replacement” on page 140.
Remove the PCIe adapter (Slot 3)
Use this information to remove the PCIe adapter from PCIe slot 3.
About this task
Attention:
• Replacing the RAID adapter might impact your RAID configurations. Back up your data before the
replacement to avoid any data loss due to a RAID configuration change.
• Read the following section(s) to ensure that you work safely.
–
“Safety” on page iii
– “Installation Guidelines” on page 51
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 11.
• If the server is installed in a rack, remove the server from the rack.
Note: The following illustration might differ slightly from your hardware, but the removal method is the same
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BPZOAqQMD37KjuxaVHVBkH
.
Procedure
Step 1. Remove the top cover. See
“Remove the top cover” on page 132.
Step 2. Remove the PCIe adapter.
Chapter 4. Hardware replacement procedures 97
To Next Page
Loading...
