Figure 104. Installing the processor
Step 3. Close the processor retainer, and push the handle to the locked position.
Figure 105. Closing the processor retainer
After you finish
1. Reinstall the heat sink. See
“Install the heat sink” on page 87.
2. Install the air baffle. See
“Install the air baffle” on page 64.
3. Install the top cover. See
“Install the top cover” on page 134.
4. Complete the parts replacement. See
“Complete the parts replacement” on page 140.
Rack latches replacement
Use the following information to remove and install the rack latches.
Remove the rack latches
Use this information to remove the rack latches.
About this task
Attention:
Chapter 4. Hardware replacement procedures 117
To Next Page
Loading...
