Lenovo ThinkSystem SR250 V2 - Install a Fan

• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 11.
• If the server is installed in a rack, remove the server from the rack.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BPZOAqQMD37KjuxaVHVBkH
.
Procedure
Step 1. Make preparations for this task.
a. Remove the top cover. See
“Remove the top cover” on page 132.
b. Remove the air baffle. See
“Remove the air baffle” on page 63.
Step 2. Remove the fan.
Figure 63. Fan removal
a.
Press and hold the fan cable latch.
b.
Disconnect the cable from the connector.
c.
Lift the fan out from the fan cage.
After you finish
1. Install a replacement unit. See
“Install a fan” on page 76.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install a fan
Use this information to install a fan.
About this task
S002
76
ThinkSystem SR250 V2 Maintenance Manual