Figure 33. Flash power module cable routing
1 Flash power module
Backplane and backplate cable routing
Use the information in this section to route the cables for the backplates and backplanes.
Four 3.5-inch simple-swap drive cable routing
Use this section to understand how to route cables for four 3.5-inch simple-swap drive model.
Notes:
• Connections between connectors;
1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n
• When routing the cables, ensure that all cables are routed appropriately through the cable guides and
cable clips.
Chapter 3. Internal cable routing 41
To Next Page
Loading...
