Lenovo ThinkSystem SR250 V2 - Security Bezel Replacement; Remove the Security Bezel

1. Install the security bezel. See “Install the security bezel” on page 122.
2. Complete the parts replacement. See
“Complete the parts replacement” on page 140.
Security bezel replacement
Use this procedure to remove or install the security bezel.
Remove the security bezel
Use this information to remove the security bezel.
About this task
Attention:
• Read the following section(s) to ensure that you work safely.
– “Safety” on page iii
– “Installation Guidelines” on page 51
• If the server is installed in a rack, extend or remove the server from the rack.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BPZOAqQMD37KjuxaVHVBkH
.
Procedure
Step 1. Use the key to unlock the security bezel to the open position.
Figure 112. Unlocking the security bezel
Step 2. Press the release latch and rotate the security bezel outwards to remove it from the chassis.
Figure 113. Security bezel removal
Chapter 4. Hardware replacement procedures 121