Lenovo ThinkSystem SR250 V2 - Install the Air Baffle

– “Safety” on page iii
– “Installation Guidelines” on page 51
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 11.
• If the server is installed in a rack, remove the server from the rack.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BPZOAqQMD37KjuxaVHVBkH
.
Procedure
Step 1. Remove the top cover. See
“Remove the top cover” on page 132.
Step 2. Lift the air baffle up and set it aside.
Attention: For proper cooling and airflow, reinstall the air baffle before you turn on the server.
Operating the server with the air baffle removed might damage server components.
Figure 53. Air baffle removal
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the air baffle
Use this information to install the air baffle.
About this task
Attention:
• Read the following section(s) to ensure that you work safely.
– “Safety” on page iii
64
ThinkSystem SR250 V2 Maintenance Manual