Lenovo ThinkSystem SR250 V2 - Flash Power Module Replacement; Remove the Flash Power Module

A video of this procedure is available at YouTube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BPZOAqQMD37KjuxaVHVBkH
.
Procedure
Step 1. Install the fan.
Figure 64. Fan installation
1 Rubber pad 2 Fan cable
a.
Align the fan with the slot in the fan cage; then, place the fan into the slot.
Attention: Make sure the fan cable is under the rubber pad and are inserted into the cable slot
as shown.
b.
Connect the fan cable to the connector by pressing it down until it clicks.
After you finish
1. Install the air baffle. See
“Install the air baffle” on page 64.
2. Install the top cover. See
“Install the top cover” on page 134.
3. Complete the parts replacement. See
“Complete the parts replacement” on page 140.
Flash power module replacement
Use the following information to remove and install the flash power module
Remove the flash power module
Use this information to remove the flash power module.
About this task
S002
78 ThinkSystem SR250 V2 Maintenance Manual