Lenovo ThinkSystem SR250 V2 - Flash Power Module Cable Routing

Figure 32. Hot-swap power supply unit cable routing
From To
1 PDB: Power distribution board signal connector
System board: Power distribution board signal connector
2 PDB: Processor power connector System board: Processor power connector
3 PDB: System power connector System board: System power connector
Flash power module cable routing
Use the section to understand the internal routing and connectors for the flash power module.
Notes:
• Connections between connectors;
1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n
• When routing the cables, ensure that all cables are routed appropriately through the cable guides and
cable clips.
40
ThinkSystem SR250 V2 Maintenance Manual