Figure 88. PCIe riser card removal
Install the PCIe riser assembly
Use this information to install the PCIe riser assembly.
About this task
Attention: Read the following section(s) to ensure that you work safely.
•
“Safety” on page iii
• “Installation Guidelines” on page 51
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BPZOAqQMD37KjuxaVHVBkH
.
Procedure
Step 1. Align the two tabs on PCIe riser assembly with the slots on the rear chassis; then, insert the PCIe
riser assembly into the connector on the system board.
Figure 89. PCIe riser assembly installation
Step 2. Carefully press the riser assembly straight down into the slot until it is fully seated.
Chapter 4. Hardware replacement procedures 101
To Next Page
Loading...
