Lenovo ThinkSystem SR250 V2 - Install the VGA Cable (2.5-Inch Drive Model)

Figure 122. VGA cable removal - 2.5-inch drive model
a. Remove the two screws that secure the VGA connector.
b. Push the VGA connector out of the front I/O assembly.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the VGA cable (2.5-inch drive model)
Use this information to install the VGA cable for the 2.5-inch drive model.
About this task
Attention:
• Read the following section(s) to ensure that you work safely.
–
“Safety” on page iii
– “Installation Guidelines” on page 51
• Turn off the server. Disconnect the power cords and all external cables. See “Power off the server” on
page 11
.
• If the server is installed in a rack, remove the server from the rack.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BPZOAqQMD37KjuxaVHVBkH
.
Procedure
Step 1. Install the VGA cable.
136
ThinkSystem SR250 V2 Maintenance Manual