Lenovo ThinkSystem SR250 V2 - Install the 3.5-Inch Backplane

Figure 49. 3.5-inch backplane removal
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the 3.5-inch backplane
Use this information to install the 3.5-inch backplane.
About this task
Attention:
• Read the following section(s) to ensure that you work safely.
– “Safety” on page iii
– “Installation Guidelines” on page 51
Note: Depending on the configuration, the following illustration might differ slightly from your backplane.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BPZOAqQMD37KjuxaVHVBkH
.
Procedure
Step 1. Install the backplane.
a.
Insert the backplane into the chassis at an angle. Make sure the pins are against the
backplane on the backside.
b.
Rotate the backplane up towards the front of the server.
c.
Close the retaining clips to secure the backplane in place.
60
ThinkSystem SR250 V2 Maintenance Manual