Lenovo ThinkSystem SR250 V2 - VGA Cable Replacement; Remove the VGA Cable (2.5-Inch Drive Model)

Figure 121. Top cover installation
After you finish
Complete the parts replacement. See
“Complete the parts replacement” on page 140.
VGA cable replacement
Use the following information to remove and install the VGA cable.
Remove the VGA cable (2.5-inch drive model)
Use this information to remove the VGA cable for the 2.5-inch drive model.
About this task
Attention:
• Read the following section(s) to ensure that you work safely.
–
“Safety” on page iii
– “Installation Guidelines” on page 51
• Turn off the server. Disconnect the power cords and all external cables. See “Power off the server” on
page 11
.
• If the server is installed in a rack, remove the server from the rack.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BPZOAqQMD37KjuxaVHVBkH
.
Step 1. Make preparations for this task.
a. Remove the top cover. See
“Remove the top cover” on page 132.
b. Remove the front operator panel (2.5-inch drive model). See
“Remove the front operator panel
(2.5-inch drive model)” on page 81
.
Step 2. Remove the VGA cable.
Chapter 4. Hardware replacement procedures 135