Figure 123. VGA cable installation
a.
Insert the VGA cable into the front I/O assembly.
b. Install and fasten two screws to secure the VGA cable.
After you finish
1. Install the front operator panel (2.5-inch drive model). See
“Install the front operator panel (2.5-inch drive
model)” on page 82
.
2. Install the top cover onto the server. See
“Install the top cover” on page 134.
3. Complete the parts replacement. See
“Complete the parts replacement” on page 140.
Remove the VGA cable (3.5-inch drive model)
Use this information to remove the VGA cable for the 3.5-inch drive model.
About this task
Attention:
• Read the following section(s) to ensure that you work safely.
–
“Safety” on page iii
– “Installation Guidelines” on page 51
• Turn off the server. Disconnect the power cords and all external cables. See “Power off the server” on
page 11
.
• If the server is installed in a rack, remove the server from the rack.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BPZOAqQMD37KjuxaVHVBkH
.
Procedure
Step 1. Make preparations for this task.
a. Remove the top cover. See
“Remove the top cover” on page 132.
b. Disconnect the VGA cable. See
“Front panel cable routing” on page 35.
Step 2. Remove the VGA cover.
Chapter 4. Hardware replacement procedures 137
To Next Page
Loading...
