Procedure
Step 1. Make preparations for this task.
a. Remove all drives and drive fillers from the drive bays. See
“Remove a hot-swap drive” on
page 72
.
b. Remove the top cover. See
“Remove the top cover” on page 132.
c. Disconnect the cables from the system board or the RAID adapter. See
“Backplane and
backplate cable routing” on page 41
.
Step 2. Remove the backplate.
a.
Open the retaining clips by rotating them up.
b.
Rotate the backplate down towards the center of the server.
c.
Lift the backplate out of the server.
Figure 51. Backplate removal
Note: Depending on the configuration, the following illustration might differ slightly from your
backplate.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the 3.5-inch backplate
Use this information to install the 3.5-inch backplate.
About this task
Attention:
• Read the following section(s) to ensure that you work safely.
–
“Safety” on page iii
– “Installation Guidelines” on page 51
• Depending on the configuration, the following illustration might differ slightly from your backplate.
Watch the procedure
62
ThinkSystem SR250 V2 Maintenance Manual
To Next Page
Loading...
