Attention:
• Read the following section(s) to ensure that you work safely.
–
“Safety” on page iii
– “Installation Guidelines” on page 51
Note: Depending on the configuration, the following illustration might differ slightly from your backplane.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BPZOAqQMD37KjuxaVHVBkH
.
Procedure
Step 1. Align the two pins on the backplane with the corresponding holes in the chassis.
Step 2. Lower the backplane into the chassis. Ensure that the pins pass through the holes and the
backplane is fully seated in place.
Figure 44. 2.5-inch backplane installation
1 Pins
2 Corresponding holes
After you finish
1. Connect the cables to the backplane. See
“Backplane and backplate cable routing” on page 41.
2. Install the top cover. See
“Install the top cover” on page 134.
3. Install all drives and drive fillers into the drive bays. See
“Install a hot-swap drive” on page 73.
4. Complete the parts replacement. See
“Complete the parts replacement” on page 140.
2.5-inch drive replacement from 3.5-inch drive bay
Use this information to remove and install a 2.5-inch drive from a 3.5-inch drive bay.
The EMI integrity and cooling of the server are protected by having all drive bays covered or occupied. The
number of the installed drives in your server varies depending on the server model. The vacant bays are
occupied by dummy trays. When you install a drive, save the removed dummy tray from the drive bay in case
you later remove the drive and need the dummy tray to cover the place.
Chapter 4. Hardware replacement procedures 55
To Next Page
Loading...
