Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BPZOAqQMD37KjuxaVHVBkH
.
Procedure
Step 1. Align the system board with serial and VGA ports on the rear side of the chassis. Carefully lower the
system board into the chassis.
a. Move the fan cables aside and make sure these cables will not interfere the installation of the
system board.
b. Place the system board flat into the chassis. Match screw slots on the system board to the
corresponding slots on the chassis.
Figure 118. System board installation
Step 2. Install all eight screws to secure the system board to the chassis according to the installation
orders as shown.
126
ThinkSystem SR250 V2 Maintenance Manual
To Next Page
Loading...
