CAUTION:
Hazardous voltage, current, and energy levels might be present. Only a qualified service technician is
authorized to remove the covers where the label is attached.
S033
CAUTION:
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with
metal, which might result in spattered metal, burns, or both.
Attention:
• Read the following section(s) to ensure that you work safely.
–
“Safety” on page iii
– “Installation Guidelines” on page 51
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 11.
• If the server is installed in a rack, remove the server from the rack.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BPZOAqQMD37KjuxaVHVBkH
.
Procedure
Step 1. Remove the top cover
Figure 120. Top cover removal
a. Press the release button and the push point at the same time; then, slide the cover toward
the rear of the server.
b.
Lift the top cover away from the server.
Chapter 4. Hardware replacement procedures 133
To Next Page
Loading...
