About this task
Attention:
• Read the following section(s) to ensure that you work safely.
–
“Safety” on page iii
– “Installation Guidelines” on page 51
• Turn off the server. Disconnect the power cords and all external cables. See “Power off the server” on
page 11
.
• If the server is installed in a rack, remove the server from the rack.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BPZOAqQMD37KjuxaVHVBkH
.
Procedure
Step 1. Install the VGA cable.
Figure 126. VGA cable installation
a.
Insert the VGA cable into the slot on the front chassis.
b.
Install the screws to secure the VGA cable.
Step 2. Push the VGA cable cover into the slot until the clips are locked.
Chapter 4. Hardware replacement procedures 139
To Next Page
Loading...
