Figure 92. Processor 3 and 4 location on the processor and memory expansion tray
Notes:
• The heat sink, processor, and processor carrier for your system might be different from those shown in the
illustrations.
• PHMs are keyed for the socket where they can be installed and for their orientation in the socket.
• See
https://static.lenovo.com/us/en/serverproven/index.shtml for a list of processors supported for your
server. All processors on the system board must have the same speed, number of cores, and frequency.
• Before you install a new PHM or replacement processor, update your system firmware to the latest level.
See “Update the firmware” on page 227.
• Installing an additional PHM can change the memory requirements for your system. See “Install a memory
module” on page 201 for a list of processor-to-memory relationships.
The following illustration shows the components of the PHM.
Chapter 5. Server hardware setup 199
To Next Page
Loading...
