Figure 93. PHM components
1 Heat sink
9 Clips to secure processor in carrier
2 Heat sink triangular mark
10 Carrier triangular mark
3 Processor identification label
11 Processor ejector handle
4 Nut and wire bail retainer 12 Processor heat spreader
5 Torx T30 nut 13 Thermal grease
6 Anti-tilt wire bail 14 Processor contacts
7 Processor carrier 15 Processor triangular mark
8 Clips to secure carrier to heat sink
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C6QgmsUMRG6ul0bHzrGmsG
• Youku: https://list.youku.com/albumlist/show/id_54461099
Procedure
Step 1. Remove the processor socket cover, if one is installed on the processor socket, by placing your
fingers in the half-circles at each end of the cover and lifting it from the system board.
Step 2. Install the processor-heat-sink module into the system board socket.
200
ThinkSystem SR860 V2Setup Guide
To Next Page
Loading...
