C
ONFIGURING
THE
S
WITCH
6-6
Rate Limiting Sets the rate limiting parameters for ports. 6-25
Storm Control Sets the broadcast storm control parameters. 6-27
Port Mirroring Sets up the port mirroring features of the switch to
enable traffic monitoring.
6-28
Cable Diagnostic Diagnoses cable faults. 6-30
TRUNKS 6-30
Membership Selects ports to group into static trunks. 6-33
Settings Configures trunk connection settings. 6-33
Rate Limiting Sets the rate limiting parameters for trunks. 6-33
LACP Setup Configures Link Aggregation Control Protocol
(LACP) on the switch.
6-35
LACP Status Shows the LACP group status. 6-36
VLANS 6-38
VLAN Membership Configure VLAN port groups. 6-39
VLAN Port Config Configures VLAN behavior for individual ports and
trunks.
6-38
QOS 6-45
Settings Sets the priority of packets forwarded through the
switch.
6-45
RSTP 6-50
Settings Configures Spanning Tree parameters. 6-51
Status Shows Spanning Tree bridge and port status. 6-55
802.1X 6-57
Settings Sets up 802.1X port authentication. 6-59
Statistics Displays the 802.1X statistics collected by the switch. 6-62
Security 6-66
IP Filter Sets up port IP control filters. 6-66
Port Security Sets security policy for ports. 6-67
Main Menu (Continued)
Menu Description Page
To Next Page
Loading...
