LevelOne GSW-1676 - Page 57

B ASIC I NFORMATION
6-9
- 10hdx: 10 Mbps half duplex.
- 10fdx: 10 Mbps full duplex.
- 100hdx: 100 Mbps half duplex.
- 100fdx: 100 Mbps full duplex.
- 1000fdx: 1000 Mbps full duplex.
• Flow Control Status – Indicates whether flow control is enabled or
disabled. (IEEE 802.3x, or Back-Pressure)
• Autonegotiation – Shows if auto-negotiation is enabled or disabled.
• Frame Type – Either “Tagged” or “All.” “Tagged” means that the port
will only receive VLAN-tagged packets. When set to “All,” the port will
also receive untagged packets.
• PVID - The VLAN ID assigned to untagged frames received on the
interface. Outgoing frames are tagged unless the frame’s VLAN ID is the
same as the PVID. When the PVID is set to “None,” all outgoing frames
are tagged. (Default: 1)
Trunk Information
• Trunk – The trunk label. “T1” through “T8” are used as trunk labels.
• Type – All trunks and ports on this switch are 10/100/1000Mbps
• Trunk Status – Indicates the speed and duplex setting of the trunk. This
can be changed on the TRUNKS > Settings page.
- Auto: Not currently connected, will auto-negotiate these settings.
- 10hdx: 10 Mbps half duplex.
- 10fdx: 10 Mbps full duplex.
- 100hdx: 100 Mbps half duplex.
- 100fdx: 100 Mbps full duplex.
- 1000fdx: 1000 Mbps full duplex.
• Ports – The ports that are members of the trunk.
VLAN Information
• VLAN ID – A number in the range 1 - 4094 which identifies the VLAN.
• VLAN Members – A list of the ports that are members of the VLAN.
By default, all ports are members of VLAN 1.
Web –
Click STATUS, Overview.